Payment & Shipping Terms:
|Material:||High Chrome Cast Alloy And Rubber||Application:||Interchangable To Minng Slurry Pump, Ash Slurry Pump, Sand Dreding Pump Parts|
|Process:||Casting||Interchangable:||Interchangable To Most Standard Slurry Pumps|
|Pump Type:||Single Stage, Horizontal|
Wear Resistant High Chrome pump parts of electric Slurry Pump
1. Slurry pump parts
Completely interchangeable with slurry pumps and gravel pumps
For unlisted slurry pump parts, OEM service offered---Drawings needed.
- Metal Liner
- Rubber Liner
- Bearing Assembly
- Pump Volute;
- Cover Plate & Frame Plate
Slurry Pump Part Material
|Part Name||Material||Specification||HRC||Application||OEM Code|
|Liners & Impeller||Metal||AB27: 23%-30% chrome white iron||≥56||Used for higher wear condition with pH between 5 and 12||A05|
|AB15: 14%-18% chrome white iron||≥59||Used for higher wear condition||A07|
|AB29: 27%-29% chrome white iron||43||Used for lower pH condition especially for FGD. It also can be used for low-sour condition and desulfuration installation with pH no less than 4||A49|
|AB33: 33%-37% chrome white iron||It can transport oxygenated slurry with pH not be less than 1 such as phospor-plaster, nitric acid, vitriol, phosphate etc.||A33|
|Expeller & expeller ring||Metal||B27: 23%-30% chrome white iron||≥56||Used for higher wear condition with pH between 5 and 12||A05|
Introduction of MiningSlurry Pump :
1. Abrasion and corrosion resisting
2. Material: hard alloy metal (Cr27, Cr28, CD4MCu) or rubber liner optional,
3. Shaft seal: packing seal, expeller seal, and mechanical seal.
4. Power driver: electrical motor or diesel engine.
The slurry pumps have pump bodies that consist of replaceable wear-resistant metal liners or wear-resistant rubber liners, and impellers can also apply wear-resistant metal material or wear-resistant rubber material. The HH type slurry pumps only apply wear-resistant metal material as their pump bodies and impellers.
Slurry pump application
Paper and Pulp
Bottom Boiler and Fly Ash