Payment & Shipping Terms:
|Material:||A05, A07, A33, A49||OEM:||Manufacture Accroding To Drawing|
|Application:||Interchangable To Submersible Minng Slurry Pump||Interchangable:||Interchangable To Most Standard Submersible Mining Slurry Pumps|
Submersible Sludge Pump,
Submersible Sand Pump
Centrifugal submersible Slurry Pump Parts Made of high chrome Cast Iron
1. Slurry pump parts
Completely interchangeable with slurry pumps and gravel pumps
For unlisted slurry pump parts, OEM service offered---Drawings needed.
- Metal Liner
- Rubber Liner
- Bearing Assembly
- Pump Volute;
- Cover Plate & Frame Plate
With ceramic coating----high hardness and fracture
toughness and wear resistant
Shaft sleeve manage wear to minimize shaft cost.
Wherever there is a bearing support for the shaft, centrifugally cast shaft sleeves are used to prevent wear to the shaft. Refurbishment of the shaft is simply a matter of replacing the sleeve and reusing the shaft.
Slurry pump cover plate & frame plate for heavy duty centrifugal slurry pump in axial direction is used to bear pressure, and the liner is wear-resistant.
Slurry pumps parts-cover plate liner & frame plate liner
The cover plate is produced using elastomer or hard metal,
such as natural rubber, high - chromium alloy, etc.
It has various sizes and styles, and the installation is very easy. Additionally, OEM design is accepted. This product is also named as slurry pump liner, and it is also an overflow component. It can form a pump chamber with throat bush and frame plate liner insert. Meanwhile, it is white iron with high-chromium alloy whose content as much as 27%, and it shows good resistance to abrasion .
High chrome alloy: A05, A07, A33, A49, etc.
Natural rubber: R08, R26, R33, R55, etc.
Other material as per requests, like stainless steel, duplex stainless steel, Nickle alloy, Alloy 20, etc.
3. Short delivery time
For some slurry pump parts, stocks are available. We have large producing capacity to shorten the delivery time.
|Part Name||Material||Specification||HRC||Application||OEM Code|
|Liners & Impeller||Metal||AB27: 23%-30% chrome white iron||≥56||Used for higher wear condition with pH between 5 and 12||A05|
|AB15: 14%-18% chrome white iron||≥59||Used for higher wear condition||A07|
|AB29: 27%-29% chrome white iron||43||Used for lower pH condition especially for FGD. It also can be used for low-sour condition and desulfuration installation with pH no less than 4||A49|
|AB33: 33%-37% chrome white iron||It can transport oxygenated slurry with pH not be less than 1 such as phospor-plaster, nitric acid, vitriol, phosphate etc.||A33|
|Expeller & expeller ring||Metal||B27: 23%-30% chrome white iron||≥56||Used for higher wear condition with pH between 5 and 12||A05|
|Stuffing Box||Metal||AB27: 23%-30% chrome white iron||≥56||Used for higher wear condition with pH between 5 and 12||A05|
|Frame/Cover plate, bearing house & base||Metal||Grey iron||G01|
|Shaft sleeve, lantern ring/resctrictor, neck ring, gland bolt||Stainless steel||4Cr13||C21|