Payment & Shipping Terms:
|Material:||A05, A07, A33, A49,R08, R26, R33, R55||OEM:||Manufacture Accroding To Drawing|
|Application:||Interchangable To Minng Slurry Pump, Slurry Pump, Sand Dreding Pump Parts||Process:||Cast|
|Interchangable:||Interchangable To Most Standard Slurry Pumps|
Foam Concentrate Transfer Pump,
Rubber Slurry Pump
Foam transfer slurry Pump Anti Acid Rubber parts
Foam transfer pumps
has been designed to increase the pumpability of frothy slurry. The pump operation is similar to hydrocyclone seperation.
The basic principle of the froth pump operation is to de-aerate or partially de-aerate the froth before it enters the pumping. Its handling capacity of the pump is muchhigher than that of other types of slurry pump without shaft seal and sealing water.
· Bearing assembly Bearing housing is installed with motor frame base or supporting plate,Pulleys can be exchanged conveniently to adjust the pump rotating speed to satisfy the varying operating condition.
· Feeding tank-Feeding tank can be steel, stainless steel or rubber coated with overflow box and tangential inlet.
· Double casings structure the pump head .Wetted parts are metal lined, rubber lined or of other non-metallic material according to the different slurries.
|Casting,||Frame plate liner,|
|Throat bush,||Expeller ring,|
|Back liner,||Bearing assembly,|
|Wear plate,||Volute liner,|
|Case, cover,||Volute packing,|
|Lantern restrictor,||Bearing cartridge,|
|Plate bolt,||Cover plate liner,|
|Shaft sleeve,||Closed impeller,|
|Cover plate liner,||Open impeller|
Bearing assembly &nd; a large diameter shaft with short overhang minimizes deflection and contributes to long bearing life. Only four through bolts are required to hold the cartridge type housing in the frame.
Liners &nd; easily replaceable liners are bolted, not glued, to the casing for positive attachment and east of maintenance. Hard metal liners are completely interchangeable with pressure molded elastomeric. Elastomeric seal rings back all liner joints.
Casing &nd; Casing halves of cast or ductile iron with external reinforcing ribs provide high operating pressure capabilities and an extra measure of safety.
Impeller &nd; front and rear shrouds have pump out vanes that reduce recirculation and seal contamination. Hard metal and molded elastomeric impellers are completely interchangeable. Cast in impeller threads require no inserts or nuts. High efficiency and high head designs are also available.
Throat bush &nd; wear is reduced and maintenance simplified by the use of tapered mating faces to allow positive accurate alignment during assembly and simple removal.
One-piece frame &nd; a very robust one-piece frame cradles the cartridge type bearing and shaft assembly. An external impeller adjustment mechanism is provided below the bearing housing for easy adjustment of impeller clearance.